KONAN - Pneumatic Line Components

Drain fluids in the pneumatic lines may increase piping corrosion resistance, and hinder the function of controls in the line, finally lead to accidents. Be sure to use air filters to remove drain fluids from the line and prevent problems.

An automatic drain has been fitted to the air filters. This separates and removes drain from the pneumatic line,thus preventing trouble.

Regulators are used to reduce the pressure of the compressed air from the compressor so that air is automatically fed at constant pressure to the pneumatic line.

This is a precision,pilot-operated regulator,capable of a wide range of stable pressure settings. The built-in check valve permits secondary pressure to be fed back to the primary side if the primary pressure supply is shut off.

The nozzle flapper high-sensitivity pilot amplification system has achieved adjustable sensitivity of 0.001MPa. Large relief flow enables strong resistance against excessive pressure at secondary side and prevents reverse flow. This regulator is suitable for balancer and tension control.

This is a regulator exclusively for use in low pressure lines. This wide range of available pressure settings facilitates precise pressure adjustments.

The nozzle flapper high-sensitivity pilot amplification system has achieved adjustable 0 to 0.04 MPa control. Outside dimensions are same as standard model of RV6-03.

Volume booster maintains pressure supply to air tanks and actuators,and provides great performance where rapid pressure relief is required. It can be operated remotely using a pilot-operated regulator at a nearby, convenient point.